- Remove unnecessary in between rate limits member vectors.
- Only switch the yaw rate limit in auto modes,
other values stay the same anyways.
- Fill gain vectors with parameters in one line.

to modularize and simplify unit testing

Signed-off-by: Claudio Micheli <claudio@auterion.com>

Signed-off-by: Claudio Micheli <claudio@auterion.com>

Since the time out is only Obstacle-Avoidance related, the new naming is more self explanatory.

Signed-off-by: Claudio Micheli <claudio@auterion.com>

Signed-off-by: Claudio Micheli <claudio@auterion.com>

With this commit the use cases will be:

Success case:
- booting, no messages about OA, pre-arm check would fail if you try to arm and OA is not yet running

Fail case:
- if OA takes longer than timeout time defined in COM_ONB_BOOT_T, then an error message is triggered.


Signed-off-by: Claudio Micheli <claudio@auterion.com>

Since onboard controllers bootup times are hardware dependent, it makes sense to have the possibility to adapt timeout time according to the specific HW.

Signed-off-by: Claudio Micheli <claudio@auterion.com>

Signed-off-by: Claudio Micheli <claudio@auterion.com>

Signed-off-by: Claudio Micheli <claudio@auterion.com>

Signed-off-by: Claudio Micheli <claudio@auterion.com>

This allows to perform pre-arm checks and prevent arming if obstacle avoidance is enabled but not yet running.
Added a print once flag to prevent excessive message spamming in QGC.

Signed-off-by: Claudio Micheli <claudio@auterion.com>

Signed-off-by: CarlOlsson <carlolsson.co@gmail.com>

 - prevents loss of numerical precision

 - prevents loss of numerical precision
 - fixes #11695

- correcting
c9e52d43
to allow 180° maximum tilt instead of landing tilt.
- Introducing tilt limitation minimums like requested in #11473

fix for issue https://github.com/PX4/Firmware/issues/11030 - "getting required buffer size failed" on jmavsim simulation on Windows 10

With a DLPF of 62.5 Hz, the sampling rate is apperently not 1 kHz anymore,
because the driver got duplicate samples and published only at 128 Hz.
We have to increase the filter back to 500 Hz so that we get 1 kHz sampling
rate, with 250 Hz publications.

Co-Authored-By: EliaTarasov <elias.tarasov@gmail.com>

Signed-off-by: Roman <bapstroman@gmail.com>

[Position|AutoLine]SmoothVel - Update position and velocity states of the trajectories in case of EKF reset. Until now, only the position reset on XY axis was properly handled. Now, xy, vxy, z and vz are handled

ManualPositionSmoothVel - Force velocity and acceleration setpoints to zero if the velocity setpoint is smaller than 1mm/s and that the acceleration setpoint is null

ManualSmoothVel - Set jerk to 1.0 during position hold to help the optimizer to converge towards 0 vel and acc

mc_att_control: replace math::min() and additional limit logic with math::constrain() calls (#11658)