This updating of the driver setting is for EMI issue with GPS and FCC.
   With this setting the clock is sinusoidal

   N.B. sd_bench fails on SanDISK HC, but Passes SanDISK **HC1** and
   Kingston cards.

   ****Use HC1 or Kingston cards!***

   Testing done on SanDISK HC all failed sd_bench with Drive/Slew other
   than default and _PIN_OUTPUT_FAST|_PIN_OUTPUT_HIGHDRIVE

	_PIN_OUTPUT_FAST|_PIN_OUTPUT_HIGHDRIVE    Square noisy, pass SanDISK HC
        _PIN_OUTPUT_FAST|_PIN_OUTPUT_LOWDRIVE     Square noisy, pass SanDISK HC
        _PIN_OUTPUT_HIGHDRIVE|_PIN_OUTPUT_SLOW    sinusoidal fail SanDISK HC, pass SanDISK HC1
        _PIN_OUTPUT_LOWDRIVE |_PIN_OUTPUT_SLOW    sinusoidal fail SanDISK HC, pass SanDISK HC1
                              _PIN_OUTPUT_SLOW    sinusoidal fail SanDISK HC, pass SanDISK HC1

   Delete auto generated vars, and others that were missed.

- partially addresses #11017

_Stof, bsearch, param_find_changed

- Use the values from landing_gear.msg

- Handled in the flight task

- landing_gear: refactor state name
- Add the keep state to the landing gear message
- Adapt FlightTaskManual, FlightTaskAutoMapper, mc_pos_control,
to review message definition

- Addressing review comments

- It takes the input from the constrains from the active flight task

- An new message is created just for the landing gear
- The old logic is repalaced by publishing this new topic

Keeps things more modular.

 * fixes parameters on Snapdragon

* added a parameter for enabled the smart battery
* start tel1 and tel2 at 921600 and max rate
* turned up the max tx rate on mavlink streams for telem1 and telem2
* turned off mavlink stream for tel1 in 4250_teal. This is connected to TX1 FTDI UART and has issues.
* moved check to 4250 board ID to start mpu9250s for Teal airframe into fmuv4 rc.board.