This is important to ensure that users are not trying to use HITL with airframes that will not work.

Commander: Fix HITL state initialization that prevented pre-flight checks to pass in HITL mode on v1.7.2

This is a minor change that fixes the ordering of the initialization.

 - the sanity check result wasn't being sent to the user and prevents landing slope, runway takeoff, and launch detector parameter updates.

This ensures that the listener is re-built when the message spec changes.

This ensures that platform is re-built if messages change.

This ensures that an update of the message spec re-generates the bridge.
;

* small bit mask fix

* Restore factory calibration values in drivers start-up sequence

* Restore factory calibration values in drivers start-up sequence (reverted from commit 09ba45501f87f77e53d670fcf880b3cfc419fe38)

* Restore factory calibration values in drivers start-up sequence

* Initialization of the Adis16448 report struct

* Add stall time after write and read cycle

* Increasing the stall time for being compatible with the B sensor version

* small clean up

* Add settling time after initialization

This reverts commit 75b93b07.

Signed-off-by: CarlOlsson <carlolsson.co@gmail.com>

 - unify commander home update

- Link supported airframes to the Airframe reference rather than portfolio pages (they may look pretty, but nowhere near as useful for developers. Add portfolio link up top.
- Change the somewhat empty "Project Milestones" to "Project Roadmap" and link to the high level roadmap. I removed the only milestone about Lorenz creating the software. If we end up adding a more detailed milestone section that could go in. 
- Added clear guidelines for users vs developers.