This commit changes old trone driver into a generic
TeraRanger driver that supports both TeraRanger One
and TeraRanger Evo.

As a part of the change a new parameter was created
SENS_EN_TRANGER that allows to specify the following
modes of operation:

0 - sensors disabled
1 - autodetect sensors
2 - use TeraRanger One rangefinder
3 - use TeraRanger Evo rangefinder

Signed-off-by: Mateusz Sadowski <msadowski90@gmail.com>

This reverts commit d1da112334a875d83abbd04c50fd3bed3b069886.

This commit adds i2c support for TeraRanger Evo sensor
by Terabee

Signed-off-by: Mateusz Sadowski <msadowski90@gmail.com>

 - move controllib_test under controllib

The provided versioning information is the same, except for some additions,
like OS version (which still need to be implemented on NuttX).

MC pos control tests: added tests to all configs that include them

MavLink spec implementation

implemented vehicle_roi topic

rename old gimbal to rc_gimbal

little changes

corrected RC Gimbal group

Starting ROI implementation in commander

implementation done, needs to be tested

uhm..

add todo

Change to float32 for x,y and z

remove mission topic again, not needed

change roi coordinates to lat, lon and alt

adjust to float64

starting mount implementation

correcting small mistakes, compiles now

add todos

further progress

implementing parameters

adjust default parameters

started implementation of mavlink

fix typo

change to lat, lon and alt

fix typo :D

change to double (to represent float64)

add global_position_

add mount topic

commander mount implementation done

cleanup

almost finished

little fix

codestyle fixes

leave pitch at 0 degrees

added pitch calculation

codestyle changes

Undo vehicle_mount, react to updated parameters, parsing of CMD_DO_MOUNT_* in mount.cpp

start implementing mode override

forgot a semikolon.

add debug

Finish implementation of mount override and manual control.

fix codestyle

correct cleanup

rename to vmount

works now

fix rebase error

fix polling

refactoring and custom airframe for gimbal

couple changes

remove warnx

almost done

finally

What is going on?

change back to actuator_controls_2

working

bump parameter version number and some clarification

fix submodules

* Low impact changes from path_cleanup branch.

This is a step towards minimizing the diff with path_cleanup branch.

* Update ecl.

* Revert matrix update.

* Revert ecl and matrix.

* Update sitl gazebo.

* Revert sitl_gazebo and matrix changes.

This reverts commit 699b6a2c.

* Use DriverFramework as a PX4 module

Targets wanting to use DriverFramework must add

   lib/DriverFramework/framework

to their config file.

Signed-off-by: Mark Charlebois <charlebm@gmail.com>

* Removed spurious code

No need to add if check before for loop

Signed-off-by: Mark Charlebois <charlebm@gmail.com>

* Added DriverFramework to NuttX configs

Added lib/DriverFramework/firmware to nuttx configs

Signed-off-by: Mark Charlebois <charlebm@gmail.com>

* Updated src/lib/DriverFramework

* Removed DF_TARGET and __DF_${OS} defines

These are now handled inside DriverFramework

Signed-off-by: Mark Charlebois <charlebm@gmail.com>

* Updated DriverFramework

Signed-off-by: Mark Charlebois <charlebm@gmail.com>

* Restored __DF_${OS}

The include files in DriverFramwork need to know the target OS.

Signed-off-by: Mark Charlebois <charlebm@gmail.com>