Troubleshooting.md

@@ -3,28 +3,23 @@
 ***
 
 
-**At program load "Syntax error pattern"** 
+## **during program open, error: "Syntax error pattern"**
 
 **Symptom** 
-during the start (loading?) of a program in the Stoll machine there's a message ""Error in sintral program"
+During the loading of a program file in the Stoll machine there's a message "Error in sintral program"
 [needed here is a photo]
 
 **Solution** 
 this can only be fixed in the Stoll M1 software where the file has been made.
 Two settings have to be altered:
 
-step 1. In menu *pattern parameters*: make sure that under *Machine attributes *>> should be: setup type = setup 1
+*step 1.* In menu *pattern parameters*: make sure that under *Machine attributes *>> should be: setup type = setup 1
 <img src="uploads/31ea6cbb09fbc90a52997ba309770540/img_20191218_120224.043.jpg" width="408" height="306">
 
 
-step 2. in Menu *Machine configuration* under *further settings*, deselect *YD yarn carrier distance, Optimize to * (so should be greyed out afterwards) 
+*step 2.* in Menu *Machine configuration* under *further settings*, deselect *YD yarn carrier distance, Optimize to * (so should be greyed out afterwards) 
 
 **Background**
 There's a mismatch with the software that we currently use (ver.....) and the Firmware of the Knitting machine
-[this should be checked with Rudi from Stoll]
-
-
-
-
-
 
+[this should be checked with Rudi from Stoll]
\ No newline at end of file